o2 Oxygen Lambda Sensor Eliminator Set KTM 990 SUPERDUKE 05 - 13/ 990 SUPERMOTO

Description

o2 Oxygen Lambda Sensor Eliminator KTM 990 SUPERDUKE 05 - 13/ 990 SUPERMOTO ALL
Improved throttle response, smoother power delivery.
Supports FI mods such as Power Commander and other mods that require the elimination of the o2 sensor
Cheaper than replacing a faulty o2 sensor
Simple to fit, No cutting or soldering required
THIS IS A SET OF TWO ELIMINATORS AND TWO BLANKING PLUGS AS PICTURED
Fits The Following Models
990 SUPERDUKE
2005 - 2013
990 SUPERDUKE R
2007 - 2013
990 SUPERMOTO SMR/SMT
ALL MODELS
990 ADVENTURE
2006 - 2013
RC8 1190
2008 - 2015
RC8-R 1190
2010 - 2015
Please note
that it is best practice to completely remove the O2 sensor from the exhaust and fit a blanking plug in its place.
Blanking plugs for this model are available in my store
M18 x 1.5 Blanking Plug
How Does An o2 Eliminator Work
The O2 sensor which is installed in the stock exhaust systems of motorcycles are used by the Manufacturer to adjust the fuelling in order to pass the emission tests for street homologation.
This is done only in a very limited RPM range under certain load situations. The intention behind it is not to improve the performance of the machine. It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process.
This can result in delayed throttle response or unsteady power delivery. If you replace your silencer or exhaust system or fuelling, it's suggested to remove the installed sensor and replace it with this eliminator.
The eliminator simulates the signal given from the O2 sensor under optimal A/F ratio conditions. This allows the bike to run under best performance conditions.
If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine.
Fitting Your O2 Eliminator
Fitting your o2 eliminator couldnt be easier.
Step 1. Locate your wiring from the o2 sensor.
Step 2. Un-clip the o2 sensor wiring connection from the main wiring loom.
Step 3. Clip the o2 eliminator into the wiring connection on the main wiring loom.
If you need any further assistance just contact me
Quality Assurance
At Redline Superbikes we pride ourselves on quality and customer service. Our products are produced with the best components available and all come with a 14 day unconditional money back guarantee. In the unlikely event that your item is damaged or malfunctioning it will be replaced at no expense to you.
Products that do not satisfy the customer can be returned within 14 days for a full refund.
Copyright © Redline Superbikes
This is done only in a very limited RPM range under certain load situations. The intention behind it is not to improve the performance of the machine. It's aimed to reduce the emissions of the engine in the specific RPM/Load situations which are tested during the homologation process. If you install an aftermarket exhaust, remove the catalyst, install a power commander or perform similar modifications we strongly suggest installation of an O2 sensor eliminator for the best performance of your machine. At Redline Superbikes we pride ourselves on quality and customer service. Our products are produced with the best components available and all come with a 14 day unconditional money back guarantee. In the unlikely event that your item is damaged or malfunctioning it will be replaced at no exp